IPhone 7 Case “Regular” 3D Printer Model
The file 'IPhone 7 Case “Regular” 3D Printer Model' is (stl) file type, size is 925.6KB.
The file 'IPhone 7 Case “Regular” 3D Printer Model' is (stl) file type, size is 925.6KB.
I had a request to remix my iPhone bumper case into a full case with a back so here it is. The back has openings for your camera and flash and protrudes just far enough to protect the camera from scrapes.
You shouldn't need to clean up the print as it comes off very clean. The attached video is from the bumper case I made but it's the same except for the added back.
The other benefit of this case is that it fits both the portrait and landscape stands I made for that bumper case;-
Portrait Car and desk stand:
https://www.thingiverse.com/thing:2431699
Landscape Car and desk stand:
https://www.thingiverse.com/thing:2431698
The original iPhone bumper can be found here:-
https://www.thingiverse.com/thing:2431697
Make sure you read the "post printing" section before putting it on your phone.
You can check out my other designs here:-
https://www.thingiverse.com/ScottyMakesStuff/designs
| iPhone7CasePlainV4.stl | 2.4MB |
