This phone holder permits to wirelessly charge your iPhone 14 Plus ( including a thin protecting sleeve ) with Ikea's NORDMÄRKE charger. At the same time, it serves as a night stand to allow for Apple's new clock function.

The phone support is tilted back 15º which should be enough to prevent it from falling out since it has no retaining lip ( intentionally ), but if anybody would like to modify the angle, just the feet have to be modified.

I have designed this in such a way that I can print it without supports, but I had to split the stand in three parts: two feet and a main part.

Attention:
You will need two feet (obviously) but they have to be mirrored copies. The feet are asymmetric so this is very important. What I did is to load the foot into Cura and then create a mirrored copy.

A countersunk M3 screw is needed for each foot. Additionally you may want to glue the back to the support ( I did not, since I want to be able to disassemble it again ).

Oh and by the way:
Why is there a cutaway? You might ask...The cutaway serves two purposes:

1. You are able to grab the phone more easily when it is on the stand.
2. The camera is on that side and it would impede that the phone lays flat on the back rest ( thus making the wireless charging more difficult ).