iPad Clamp
You will need the 10mm square pipes and the 3mm screws for assembly. To hold a 10-inch iPad sideways, you need two 250 mm square pipes. (STANDARD AB Parts)
I also prepared a clamp with a deep jaw. 50 mm longer than standard. It was hard to grab when using a strange case, so I tried lengthening it. (LONG JAW CD Parts)
[ iPadClampPINS.stl ]
The stopper at the top of the square pipe is treated with a bond.
[ iPadClampCoverPusher.stl ]
The iPad case can get in the way of camera photography. It is a stick that pushes it back.
https://denshiman.com/robot.html
https://denshiman.com/10mm_square_pipe.html
| iPadClamp-A.stl | 62.0KB | |
| iPadClamp-B.stl | 26.8KB | |
| iPadClamp-C.stl | 61.2KB | |
| iPadClamp-D.stl | 26.8KB | |
| iPadClamp-d48mm.stl | 133.9KB | |
| iPadClamp38mmX35.6mm.stl | 20.2KB | |
| iPadClamp41.5mmX41.5mm.stl | 20.2KB | |
| iPadClamp43mmX43mm.stl | 20.2KB | |
| iPadClamp46mmX42mm.stl | 20.2KB | |
| iPadClamp50mmX50mm.stl | 62.8KB | |
| iPadClamp86mmX62mm.stl | 60.0KB | |
| iPadClampCoverPusher.stl | 28.2KB | |
| iPadClampPINS.stl | 62.2KB |
