InVitro Slice Recording Chamber For Rodent Brain Sections 3D Printer Model
The file 'InVitro Slice Recording Chamber For Rodent Brain Sections 3D Printer Model' is (scad,stl) file type, size is 289.0KB.
The file 'InVitro Slice Recording Chamber For Rodent Brain Sections 3D Printer Model' is (scad,stl) file type, size is 289.0KB.
This is a slice chamber that will go on to the scientifica adapter for electrophysiolgy recordings.
This will accommodate a RC-26GLP recording chamber.
https://www.warneronline.com/low-profile-open-diamond-bath-imaging-chamber
This has an inlet slot for aCSF tube and outlet slot for vacuum tube.
This file also has two additional cylindrical pillar like tube-holders for secondary perfusion if needed for experiments like glutamate uncaging. In the openSCAD code, the last section. These pillars have holes to put button magnets for attachment at the bottom and one through hole for putting a 1.27 mm OD tube thorough for inlet and outlet.
Update: I have put other variations of the model also. The one without the tube holders and the one with the tube holders shifted to base.
Update2: Changed the diameter of the tube holes to accept 18 Gauge needle (OD=1.27mm).
Update3: Changed the position of magnet holes on the main disc as they were interfering with the pillar magnets. Now if the polarity of the magnets is maintained, they should enhance each other.
| slice_holder.scad | 2.3KB | |
| slice_holder.stl | 1.3MB | |
| slice_holder_without_secondary_tube_holders.stl | 917.4KB | |
| slice_holder_with_secondary_tube_holders_translated.stl | 1.3MB |
