Instrument Strap Clip + Cable Retainer 3D Printer Model
The file 'Instrument Strap Clip + Cable Retainer 3D Printer Model' is (stl) file type, size is 150.8KB.
The file 'Instrument Strap Clip + Cable Retainer 3D Printer Model' is (stl) file type, size is 150.8KB.
This is a strap clip to tame the end of your instrument's strap as well as its cable.
This is similar to the Maxonix CableKey, but allows easy insertion/removal of the cable; no need to remove the whole clip or awkwardly feed the cable through. It prevents the cable from breaking your instrument's jack, and is more convenient than the traditional method of feeding the cable through/around the strap.
It also doubles as way to keep the two loose ends of the strap together rather than flopping around when you put your guitar/bass onto its stand.
There are 2 inch (50.8mm) and 3 inch (76.2mm) versions, as well as options without the cable retainer.
The strap clip is made to fit nylon/polypropylene straps of about 1.5mm in thickness. Leather may be too thick, but YMMV. It shouldn't slide around due to the texturing on the inside.
The cable retainer fits instrument cables of around 8mm in thickness. I tested it with chunky rubber-wrapped Pig Hog cables and thinner woven cables (pictured).
| strap_clip_2in.stl | 194.1KB | |
| strap_clip_2in_no_cable.stl | 175.9KB | |
| strap_clip_3in.stl | 247.2KB | |
| strap_clip_3in_no_cable.stl | 239.8KB |
