Instax 200/210 Photo Eject Slot Panel 3D Printer Model
The file 'Instax 200/210 Photo Eject Slot Panel 3D Printer Model' is (stl) file type, size is 28.1KB.
The file 'Instax 200/210 Photo Eject Slot Panel 3D Printer Model' is (stl) file type, size is 28.1KB.
Replacement panel/cover for the photo eject slot on top of the Fujifilm Instax 200/210 camera. My secondhand Instax 210 was missing this panel, so photos would just fall to the ground instead of staying on top when ejected.
To attach this part to the camera, just apply some double-sided tape to the underside of the part along the longer edges. Note that the slot is offset from the center - make sure the part is rotated so that the slot is closer to the rear film door (away from the lens)!
| instax_210_slot_panel.stl | 136.6KB |
