Inside Spool Silica Gel Container (small Beads Compatible) 3D Printer Model
The file 'Inside Spool Silica Gel Container (small Beads Compatible) 3D Printer Model' is (3mf,stl) file type, size is 737.3KB.
The file 'Inside Spool Silica Gel Container (small Beads Compatible) 3D Printer Model' is (3mf,stl) file type, size is 737.3KB.
Tenshe's excellent design was updated to be able to hold smaller silica beads than the 3mm ones recommended for the original design. Using 3-5mm beads is still recommended even with the remix, but this model should not allow smaller beads to escape the container from the top or bottom side anymore.
But if you want to recycle desiccant packs coming with your 3D spools, go ahead rip open these bags, oven dry them and fill up this container at will.
Still compatible with the very cheap and common hygrometers you will find on amazon / aliexpress.
This design works with a wide range of spools, leaving ample room for air / beads contact and circulation even if used in vacuum sealed bags, and with an hygrometer status of each bag can be individually monitored at a glance.
Uniformly scale to 50mm for X/Y for hygrometer fit if needed.
For easy fill/refill a screw on funnel is also available.
| Silica_Container_Remix_A1M.3mf | 294.6KB | |
| Spool_Silica_Container.stl | 1006.4KB | |
| Spool_Silica_Lid.stl | 128.5KB |
