Inlet Barb For JT750 Water Pump For 3/8″ Or 9.5mm ID Tubing 3D Printer Model
The file 'Inlet Barb For JT750 Water Pump For 3/8″ Or 9.5mm ID Tubing 3D Printer Model' is (stl) file type, size is 129.0KB.
The file 'Inlet Barb For JT750 Water Pump For 3/8″ Or 9.5mm ID Tubing 3D Printer Model' is (stl) file type, size is 129.0KB.
Made for the JT-750 12 volt submersible pump. Wouldn't be surprised if the pump is sold under different model names depending on the vendor. Slips right onto the inlet on the body of the pump and is a typical barb for 3/8" or 9-9.5mm ID tubing. I used a kind of rubber cement on the outside of the pump inlet body to seal the two pieces with the assumption it can be removed if need be. Hasn't leaked for me yet. Hope this helps.
| 375in_9.5mm_JT750_Water_Pump_Barb_v2.stl | 398.7KB |
