Adapted from an idea elsewhere where the STL wasn't available, this is a trophy for Ingress events. The only thing that makes it Ingress specific is the design on the medallion so swap that out and Bob's your close relative a generation up.
Two sizes of base supplied, 60mm and 75mm square. Use the appropriate windows for the size chosen. The pillar screws on to the base, and inside is space for a 14mm balloon light although that hasn't worked as well as I hoped. Windows push fit into the holes in the base. a dab of superglue wouldn't go amiss to keep them in place. Likewise glue the top to the main part of the base once the windows are in and the medallion into the top of the pillar.
Two versions of the medallion are supplied, one needing a filament change at height and the other as two STLs (fore and back) suitable for a Prusa MMU or similar to embed the design into the body of the medallion.
| trophy-base-75.stl | 185.9KB | |
| trophy-base.stl | 182.5KB | |
| trophy_medallion.stl | 131.3KB | |
| trophy_medallion_back.stl | 131.3KB | |
| trophy_medallion_fore.stl | 107.3KB | |
| trophy_pillar.stl | 6.4MB | |
| trophy_windows-75.stl | 8.7KB | |
| trophy_windows.stl | 9.5KB |
