I designed this part in order to reorient my Infiray P2 Pro to the same end of my smartphone as its own cameras instead of plugging into the bottom of my phone and to make it easily mountable on my microscope.

This enabled a better alignment of the smartphones cameras with the Infiray P2 Pro camera to improve the PIP alignment within the InfiRay P2 Pro app.

The P2 Pro's magnetic macro lens is compatible with this model.

The 14/20 threaded inserts are installed on three sides with one side being reserved for the cameras usb-c connector, see Post-Printing section for more info.

I accounted for the 0.2mm layer blobbing in the internal dimensions of this model therefore it should be dimensionally accurate while leaving enough free space to permit a snug insertion and removal of the P2 Pro from the case, there are slots through the rear face to aid cooling and to provide slots to aid ejecting the camera from the rear if its fitting to the print is a little too snug with your printers output.