I wanted a toolholder for all my inbus keys, found one here on thingiverse, but it was flat.
I do have a toolbag, which only has pockets for the typical screwdriver, and i wanted something that fit where a screwdriver is, doesnt slip through the pockets, and maybe fans the inbus keys a bit out, so you can get them out easier.
So i modelled this up in fusion 360, did one prototype where all the holes where off, did a second one, and thats the final one you see in the photos.
And i must say, it does that job very well!
Happy printing!
| Inbushalter.stl | 413.5KB |
