The file 'In The Flow Temperature Measuring Point For Liquids/air For NTC 3470 Temperature Sensor 3D Printer Model' is (stl) file type, size is 77.1KB.
Since I am currently working on a Peltier element and water cooling project, I needed a measuring point for the sensor of the thermostat, which measures in the flow of the system.
The system can be operated with 4mm or 8mm tubes (inner diameter).
The connections I have glued in with 5 minutes of epoxy (super glue should work too).
Tip: Isolate the housing to increase the accuracy of measurement.
Just leave a comment if other diameters are needed.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
The standard sensor has a diameter of 4mm! But now I have found one with 5mm, and therefore created a second version for 5mm sensors!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Have fun, like, and share your makes...
SG
.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-.-
Da ich im Moment an einem Projekt mit Peltierelement und Wasserkühlung arbeite, brauchte ich eine Messstelle für den Fühler des Thermostats, der im Fluss der Anlage misst.
Das System kann mit 4mm oder 8mm Schäuchen (inn. Durchmesser) betrieben werden.
Die Anschlüsse habe ich mit 5 Minuten Epoxy eingeklebt (Sekundenkleber sollte auch funktionieren).
Tipp: Isoliert das Gehäuse um die Messgenauigkeit zu erhöhen.
Hinterlasst einfach einen Kommentar, falls andere Durchmesser benötigt werden.
Shopping List:
Made for this Projekt: https://www.thingiverse.com/thing:3084960
Have fun, like, and share your makes...
SG
| 8mm_in_flow_measure_point_a.stl | 68.1KB | |
| 8mm_in_flow_measure_point_b.stl | 260.0KB | |
| 8mm_in_flow_measure_point_c_4mm.stl | 268.1KB | |
| 8mm_in_flow_measure_point_for_5mm_sensors.stl | 381.3KB |
