Improved XYZ 20mm Calibration Cube 3D Printer Model
The file 'Improved XYZ 20mm Calibration Cube 3D Printer Model' is (stl) file type, size is 333.7KB.
The file 'Improved XYZ 20mm Calibration Cube 3D Printer Model' is (stl) file type, size is 333.7KB.
Remix of the simple calibration test cube and the "Improved" version for your 3D printer with X, Y & Z written on the axis.
It has been changed with shaved edges/ rounded corners to improve accuracy of measurements.
To further calibrate your 3D printer print one out and you can then measure this models dimensions against the expected dimensions.
Once this is done you are able, if your 3D printer allows it, to adjust your Steps per mm in your printers firmware.
if:
e= expected dimension
o = observed dimension
s = current number of steps per mm
then:
(e/o) x s = your new number of steps per mm
Update:
I figure I would throw in the Torture test cube, it is 30mm³.
I did the same sort of shave of corners, haven't yet printed but maybe it adds another level of torture.
| Improved-Torture-XYZ_cube.stl | 1.0MB | |
| xyzCalibration_cube-Improved-V2.stl | 17.1KB | |
| xyzCalibration_cube-Improved.stl | 15.2KB |
