Illusionist’s Locket 3D Printer Model
The file 'Illusionist’s Locket 3D Printer Model' is (stl) file type, size is 642.3KB.
The file 'Illusionist’s Locket 3D Printer Model' is (stl) file type, size is 642.3KB.
Based on other deisgns, but fortified to print well without breakable joints.
NOTE: There are two versions of the bases. You'll want to get one of the three following setups:
Pill bottle version: locket_right_base_pill, locket_left_base_pill
locket: locket_right_base, locket_left_base
no hole for necklace: replace the right base with pill_right_base_nh or locket_right_base_nh
Pin will snap into place with soft PLA. Must move it around a little to get it to fully settle. Mine needed some coaxing and tapping. This aids in it lasting longer.
| locket_left_base.stl | 258.2KB | |
| locket_left_base_pill.stl | 279.6KB | |
| locket_left_top.stl | 197.1KB | |
| locket_right_base.stl | 259.8KB | |
| locket_right_base_nh.stl | 269.4KB | |
| locket_right_base_pill.stl | 328.8KB | |
| locket_right_top.stl | 196.8KB | |
| pill_right_base_nh.stl | 281.5KB | |
| pin.stl | 189.1KB |
