IKEA SKÅDIS (Skadis) Tool Holders 3D Printer Model

Author: @
License: CC BY
File formats: stl
Download type: zip
Size:129.59 KB

The file 'IKEA SKÅDIS (Skadis) Tool Holders 3D Printer Model' is (stl) file type, size is 129.59 KB.

Summary

Design

Compared to other designs for plier holders I made following design decisions

  • The holders are stronger and beefier to widstand a bit more abuse
  • The holders have tabs added in addition to the hooks to make them clip onto the Skadis board firmly. Some tool holders I have tried tended to clip out when I was taking my tool.
  • The holders can be printed without any supports

Printing

  • Use PET-G to print the holders. You need a little bit of flex when clipping the holder onto Skadis board. If you use a firm material like ABS it may be very hard to clip the holder onto the board.
  • Use 4 or 5 perimeters to make sure the holder is strong, Especially tabs and hooks.
  • No supports needed if your cooling is sufficient.

Installation

  • insert the hooks into the board holes
  • push the holder down and towards the board until it clicks into place
  • verify both books and the tabs have locked into the holes properly

Uninstallation

  • Firmly but carefully lift both tabs away from the board and push the holder upwards so that the hooks unhook from the board
CrimpersHolder-12x39.stl
CrimpersHolder-23x53.stl
CrimpersHolder-25x53.stl
HammerHolder-Big.stl
HexHolder-10-1.5.stl
PliersHolder-Big.stl
ScrewDriverHolder.stl