IKEA Lack Table Stacker (for Shorter Screws) 3D Printer Model
The file 'IKEA Lack Table Stacker (for Shorter Screws) 3D Printer Model' is (stl) file type, size is 129.8KB.
The file 'IKEA Lack Table Stacker (for Shorter Screws) 3D Printer Model' is (stl) file type, size is 129.8KB.
I made this remix because the original file didn't have a continuous hole in the bottom to put the screw through.
I also only had 20 mm long screws, which were a bit too short for the original model. Now the step at the bottom is about the same height as the other part that is screwed under the table legs. The advantage is that one type of screw can now be used.
I used 5.0 x 20 mm screws for this.
The lower hole has a diameter of 6.5 mm and the upper hole has a diameter of 13 mm. Accordingly, 5.0 mm or 6.0 mm screws can be used.
| bottom_table_nipple_modified.stl | 432.1KB |
