IKEA LACK ENCLOSURE V1 3D Printer Model
The file 'IKEA LACK ENCLOSURE V1 3D Printer Model' is (stl) file type, size is 4.6MB.
The file 'IKEA LACK ENCLOSURE V1 3D Printer Model' is (stl) file type, size is 4.6MB.
Check out Version 2 here: https://www.thingiverse.com/thing:2776584
This includes a 3,4,5 & 6mm version of the setup with a slightliy increased internal floor space and a variety of heights to fit your printer.
Version 1 - Below:
If you print it out please remember to share your make. It's always good to how other people have used the models :) Thanks!
Looking for something specific? Use the contents section on the left to navigate around. If you spot any errors in this post please let me know and I'll update.
This is a remix of the model made here http://www.thingiverse.com/thing:2012384
I loved this model due to the simplicity of the removable top. Since I wanted side panels I modified the design slightly to accommodate this while still allowing you to remove the top in one piece. So once you remove the filament you can just lift off the top table with the plexiglass attached.
Features
| Leg_Upper_Template.stl | 638.3KB | |
| Lower_Leg_Back_Left.stl | 249.6KB | |
| Lower_Leg_Back_Right.stl | 249.6KB | |
| Lower_Leg_Font_No_Tabs.stl | 1.6MB | |
| Lower_Leg_Front_Left.stl | 809.9KB | |
| Lower_Leg_Front_Right.stl | 809.9KB | |
| Top_Leg_Back_Left.stl | 661.3KB | |
| Top_Leg_Back_Right.stl | 661.3KB | |
| Top_Leg_Front_Left.stl | 646.3KB | |
| Top_Leg_Front_Right.stl | 646.3KB | |
| Upper_Legs_Long_490mm.stl | 2.6MB | |
| Upper_Leg_Back_Left.stl | 718.0KB | |
| Upper_Leg_Back_Right.stl | 718.0KB | |
| Upper_Leg_Front_Left.stl | 469.4KB | |
| Upper_Leg_Front_Right.stl | 469.4KB | |
| Upper_Leg_Long_500mm.stl | 2.8MB | |
| Upper_Leg_Long_500mm_Corrected.stl | 646.6KB |
