PRINT TOWER by Lilik7
created from 4 Ikea Lack tabels (3 boards and 16 legs)
You need:
4 x 1000x500x2 (or 4) plexiglass
32x 4x40 screw
8x 3x15 screw
22x 4x25 bolt
6x 4x40 bolt
12x 4x25 bolt (countersunk head)
34x M4 nut
74x M4 pad
You print:
2x A-LACK
2x B-LACK
2x C-LACK
6x D-LACK
2x E-LACK
4x F-LACK
4x G-LACK
1x handle 3
1x handle D
(1x CAM holder)
(1x screen cover)
Instruction:
1/ Assemble T1 and T2 (use Ikea instructions)
2/ Connect T1 and T2 with G - LACK
3/ Assemble T4 - between legs and board use A - LACK, B - LACK and 2x F - LACK
4/ Screw on A - LACK, B - LACK and 2x F - LACK on board of T2 and screw on T3 on T2
5/ Screw on 2x C - LACK and 2x E - LACK on T3
6/ Put on it T4 and screw it
7/ Measure and cut the plexiglass
8/ Catch on side and back plexiglass
9/ Connect D - LACK
10/ Measure position of front plexiglass (doors) and screw it
11/ Put HANDLE on doors (50 mm between screws)
12/ If possible, cut a hole for the cables
13/ Place the 3D printer
14/ Send photos of your print tower!
| A_-_LACK.stl | 72.4KB | |
| B_-_LACK.stl | 72.4KB | |
| CAM_holder.stl | 137.3KB | |
| C_-_LACK.stl | 73.2KB | |
| D_-_LACK.stl | 44.1KB | |
| E_-_LACK.stl | 34.5KB | |
| F_-_LACK.stl | 33.7KB | |
| G_-_LACK.stl | 22.7KB | |
| holder_3.stl | 40.5KB | |
| holder_D.stl | 35.2KB | |
| Screen_cover.stl | 73.1KB |
