Planning to build an enclosure for my Ender 3 V2, i designed this bracket to raise a Ikea Lack Table, because the Ender 3 V2 wouldn't fit under the default leg height of these tables. Its a simple design that uses 4 woodscrews (e.g. 4x40 mm) per corner.
Keep in mind that these brackets do not implement a window/sidepanel holder! Those need to be designed separetly and thus give you a bit more flexibility in design.
Printing:
-no supports needed
-i used a large 0.8 mm nozzle to print these in just 2.5 hours per piece. 2 walls and 20% infill. -->used about 115g of PETG filament per bracket.
Make sure your settings allow for good layer adhesion, especially in the thinner top part where the 4 holes sit.
| Ecke_lack.ipt | 313.5KB | |
| Lack_raiser.stl | 201.9KB |
