Ikea Hack Lack Enclosure V1.0 3D Printer Model
The file 'Ikea Hack Lack Enclosure V1.0 3D Printer Model' is (stl) file type, size is 312.5KB.
The file 'Ikea Hack Lack Enclosure V1.0 3D Printer Model' is (stl) file type, size is 312.5KB.
THIS IS A WORK IN PROGRESS TO ADD MORE PIECES
Ikea Lack enclosure for 3d printers, the "foot support " raise the table about 6cm.
The corner pieces have holes to places neodimiun magnet to hold a polycarbonate windows.
All pieces must be attached with screw to the table.
Like i said is a work in progress, in the future i `ll upload more functional pieces.
Enjoy
Update1:
Added a few more pieces¡
-Cable trought: to properly run cables from the bottom to the top.
This pieces consist in three parts.
-PowerSupply support for a TFX PSU . Two parts
-Control panel for on-off switchs and two usb.
For the usb i use this: https://es.aliexpress.com/item/USB-A-Female-Breakout-Board-5V-Power-2-54mm-Header/32492164824.html?spm=a2g0s.9042311.0.0.tD0Yan
-Cable clamp with ties for cable management
| Corner_L.stl | 69.7KB | |
| Corner_R.stl | 87.1KB | |
| Foot_support.stl | 130.4KB | |
| panel_onoff.stl | 73.0KB | |
| panel_on_off_frontal.stl | 96.2KB | |
| PASACABLES.stl | 227.0KB | |
| soporte_fuenteA.stl | 42.7KB | |
| soporte_fuenteB.stl | 23.3KB | |
| sujetacables.stl | 127.0KB | |
| TAPA_PASACABLES.stl | 132.4KB | |
| TAPON_PASACABLES.stl | 177.2KB | |
| TAPON_PASACABLES2.stl | 146.2KB | |
| windows_Holder.stl | 55.7KB |
