Igloo BMX Cooler Upper Hinge 3D Printer Model
The file 'Igloo BMX Cooler Upper Hinge 3D Printer Model' is (stl) file type, size is 64.7KB.
The file 'Igloo BMX Cooler Upper Hinge 3D Printer Model' is (stl) file type, size is 64.7KB.
I ran it both laid down and vertical with tree supports, both worked and were strong, I intentionally made the pin-hole small, you need to run a 1/8" drill bit(.125in or 3.18mm) through the hole after, the pin should fit snug. to remove the old upper hinge you need to pry the lower section out of the cooler with a flat-blade screwdriver and then punch the pin out to separate the two halves then push the pin back through the new part, snap the lower assembly back in the cooler and screw the upper to the lid.
| Igloo_BMX_upper_hinge_v1.stl | 203.8KB |
