I.O.N.S. NAS 3D Printer Model
The file 'I.O.N.S. NAS 3D Printer Model' is (stl,zip) file type, size is 838.6KB.
The file 'I.O.N.S. NAS 3D Printer Model' is (stl,zip) file type, size is 838.6KB.
The prIvate OpeN Source Network Attached Storage or short I.O.N.S. N.A.S. was created because i needed an NAS for my Data. Sadly I couldn't find a design that fulfilled all my wishes.
As some people probably already recognised the outer design is somewhat based on/inspired by the Xbox Series X.
The NAS is designed for two 63,5 mm(2,5 inch) drives for storage and a Raspberry Pi 4 as the brains of operation, but you can probably use any small single board computer.
The I.O.N.S. N.A.S. is able to house a 120mm Fan (I had a NF-F12 5V in mind). It's not necessary for most cases though.
If you would like a version without the possibility to hang it on the wall or Without the Icon, just leave a comment.
Due to the size of the parts I designed them to be printable with a 1mm nozzle.
| Base-withHook-V2.stl | 490.8KB | |
| Case-withHook-V2.stl | 408.1KB | |
| DiskTray-V2.stl | 19.8KB | |
| RaspberryPlate-V2.stl | 516.3KB | |
| stand.stl | 95.6KB | |
| version-1.zip | 721.3KB |
