Hyundai I30 Window Clip Regulator – Heavy Duty Version 3D Printer Model
The file 'Hyundai I30 Window Clip Regulator – Heavy Duty Version 3D Printer Model' is (stl) file type, size is 2.0MB.
The file 'Hyundai I30 Window Clip Regulator – Heavy Duty Version 3D Printer Model' is (stl) file type, size is 2.0MB.
After replacing my car window clips with Geckoslayers amazing design and having it break only a few weeks later, I decided to beef it up and add additional material where I could, without compromising the function of the clip.
Depending on your printing tolerances, you may need to mill out some of the spaces. I recommend using a 2.5mm drill bit, which seems to give a good fit along the slide rails. If you have a dremel or similar then probably use that but i was able to use a drill bit and just push it sideways as required.
Also I discovered that putting the wire back together is actually quite easy if you drive the assembly hard up against the non rotating pulley and then use a g-clamp between the clip and the end stop to take out the spring tension so you can reconnect the last wire by hand with minimal effort. (see photo)
| i30_window_clip6.stl | 20.1MB |
![Store Window Set [playfab 184002 – Playmobil Compatible] 3D Printer Model](https://cdn.3axis.co/assets/5f/21/3f/37/5f213f37-110b-45c5-bc3c-6e455644f7e2/images/549a5879-7b1c-4b5b-a507-2331fe7046c4_thumb.jpg)
