This is the Floss 3.0 Command Center. The perfect accessory for your long range Floss 3.0 where signal reception is a high priority. It includes a GoPro Hero 5/6/7 mount (Session mount will be added soon) that is fully adjustable between 10 - 40 degrees. There are markers in 5 degree increments so you can accurately and consistently adjust the angle for your needs. Props are NOT IN VIEW when shooting in the WIDE setting(as I do). If you use Superview, I believe you need to be at 15 degrees or more to keep the props out of view. It also includes a spot for your VTX, RX, GPS, SMA antenna, along with both horizontal and vertical Immortal-T options. You can fit both a horizontal and vertical Immortal-T antennas for diversity. The vertical antennas are positioned to allow good front/back visibility without being blocked by the GoPro. The back spine is also a great spot for an LED strip like the 8-LED WS2812 programmable RGB strips.

For best fit and function, the components I used and designed this for are the TBS Unify Pro V3 video transmitter, TBS Crossfire NanoRX receiver, and the HGLRC GPS. Other components may work but those are the components I have tested and they work very well.

Also included is a mount for your XT60 connector and a 1000mfd 50v Panasonic FM series capacitor on the rear.

You will need (2) M3x25mm bolts with flanged lock-nuts for the GoPro mount. I highly recommend using washers to mount the Command Center to the Floss top plate. There is also a hole in the bottom for a zip-tie to help secure the middle part of the mount. You will need to use zip-ties to secure the Immortal T antenna if you choose to use the vertical mounting option(s).

Here is the full list of components used to build my 7" long range setup:
7" Floss 3 w/ braces
BrainFPV Radix FC
Hyperlite 2408.5-1622kv
Aikon AK32 35a ESC + 50v 1000mfd capacitor
WhoCares 2200mah 6s
HGLRC GPS
Dal Cyclone 7056
Runcam Micro Eagle
Unify Pro V3 w/ Spedix Pagoda
Crossfire NanoRX w/ Immortal-T

Here's a video of it in action, 2 miles out.
https://www.youtube.com/watch?v=cgx8gPFdRXs

UPDATE: 6/27/19 - Added Session Mount + modified printing instructions