hi,please like if you enjoy the green wall i made it pretty easy
for best results use 100 infill and nylon to print and the slower the better
its a easy system even for the first time grower (combo above below)
you wil need;
-- cotton cord aprox 5-10mm (the bigger the better but shoelace also works)
-- 10mm tube and pump (you can also give water by hand)
-- screws with 6mm head or bigger (nail also works)
--pots or soil bags (link below)
--and plants off course (combo from picture down below)
--black filement (if not the darker the better otherwise you get algea grow)
extra info;
--for outdoor best to use UV protective epoxy (keeps it waterproof to)
just 1 layer epoxy painted on the module no glasfiber and best not the bottem
i find it best works best with small organic grow bags and a light soil mix
-- for indoors if your area is dry and hot best is to use terra cottem (link below)
--if you do Drain to recycle water system best is to use a airpump and enzym
to stable the PH also its best to use perlite in the soil mix
-- when verry hot and dry use terracottem in the soil and a little bit off hydroponic rockwool in the wall module but be carefull not to block watertube (link below)
the module is 100x100x100mm
the pothole is 54x54x70mm
you can also print the module without potholder and use what you like use silicon or all fix
to make it waterproof the hole is fit for 60x60x70mm pot or bag or you can print the pot from the file seprate (check STLl file's )
enjoy it M_X
terra cottem link
https://www.terracottem.com/en
plant combo like picture
Bromeliads
Fern
Devil's ivy
Succulent plant
Dracaena
Sea thrift
Bird's-nest fern
Moses-in-the-cradle
Stephanotis floribunda
Phlebodium aureum
Pteris cretica
Davallia fejeensis
Codiaeum variegatum
Lipstick plant
Succulents
| green_wall_module1.stl | 291.2KB | |
| module_foot_3.stl | 3.2KB | |
| module_pot_2.stl | 67.3KB | |
| module_top_4.stl | 3.0KB | |
| module_without_potholder.stl | 194.2KB | |
| module_without_potholder2.stl | 67.2KB |
