Hydro Flask AirTag Case Holder 3D Printer Model
The file 'Hydro Flask AirTag Case Holder 3D Printer Model' is (stl) file type, size is 843.3KB.
The file 'Hydro Flask AirTag Case Holder 3D Printer Model' is (stl) file type, size is 843.3KB.
Tired of your expensive Hydro Flasks disappearing?
Conceal an Apple AirTag in the Flex Boot and never lose one again!
The AirTag Case / Holder fits in the bottom of the Hydro Flask Small Flex Boot. The boot used to protect the 24,21 and 18 oz. sized bottles.UPDATE Added a larger sized bottom for the Medium Flex Boot which is used on the 32 and 40 Oz bottles. Uses the same tops.
Three files to down load:
1 Bottom
1 Top Smooth (hard to tighten and hard to loosen) - better to conceal AirTag
1) Top Grip - ridges on edge to allow easier tightening
Threads will print fine without any support, bottom of the base may need support to be completely smooth.
| Hydro_Flask_boot_32_40_oz.stl | 518.7KB | |
| Hydro_Flask_Bottom.stl | 518.7KB | |
| Hydro_Flask_Top_Grip.stl | 516.8KB | |
| Hydro_Flask_Top_Smooth.stl | 458.8KB |
