//UPDATE 2022-05-30/////////////////////////////////////////////////////////
Thanks to some feedback from CatisCat
i modified the slider to work with less tolerances,
or stricter to say so.

HB RC Final-LT.stl is the model you look for
when you aim for a [maybe too] TIIIGHT fit.
The 'conter pads' are extruded some more,
so the cable ties hopefully won't be necessary anymore.

Appreciate every feedback,
since i only have it printed at my wonky Anet A8 just once.
////////////////////////////////////////////////////////////////////////////////////////////

This is my second try to design a hydraulic lift / ramp.

The new stand is on the right side in the picture, had it printed just once till now.

Print the .STL two times to get a model that holds hotwheels cars on its own in every desired height.

Maybe the sliders need some support, maybe it could be achived with bridging.
Cause my lazy adjusted printer needed support i printed it with some.
Therefore it needed a little post-print sanding.

Also a little bit of infill could be good, i had none and got a small hole on the top of it.

I printed with these settings:
.3 nozzle
.1 layer height

0% infill
6 shells
Bottom 6 layers, top 8 layers

196° / 60°
PLA