Hot Rod Business Card Holder W/Bearing In Wheels! + Short Bed/LongBed 3D Printer Model
The file 'Hot Rod Business Card Holder W/Bearing In Wheels! + Short Bed/LongBed 3D Printer Model' is (stl) file type, size is 6.5MB.
The file 'Hot Rod Business Card Holder W/Bearing In Wheels! + Short Bed/LongBed 3D Printer Model' is (stl) file type, size is 6.5MB.
I added a handful of detail to this truck to have it stand out more. I also do my best to design prints that require no supports. This one should require no supports. All little areas that would cause issues have been edited to allow it print more friendly.
My number and business name are in the bed. To remove this just load it up into tinkercad and add a square to full in the holes.
Edited so pipes and engine are now larger, Has front and rear wheels for a slight offset.
I just uploaded two more files if you want to put some bearing in the wheels for the truck to move around. Who does not want a moving card holder? lol
Just use the bearing axle, and wheel file, the truck is the same.
7/5/18 Edited to make a short bed version, so if you print make sure you have the short bed files or not.
| Hot_Rod_Truck_Card_Holder_Axle.stl | 26.7KB | |
| Hot_Rod_Truck_Card_Holder_Bearings.stl | 8.5MB | |
| Hot_Rod_Truck_Card_Holder_Bearings_axle.stl | 77.9KB | |
| Hot_Rod_Truck_Card_Holder_Bearing_Back_Larger_Wheel.stl | 292.1KB | |
| Hot_Rod_Truck_Card_Holder_Bearing_Front_wheel.stl | 292.1KB | |
| Hot_Rod_Truck_Card_Holder_Wheel.stl | 267.6KB | |
| Short_Bed_Front_Wheel.stl | 249.4KB | |
| Short_Bed_Hot_Rod_Truck2.stl | 6.8MB | |
| Short_Bed_Hot_Rod_Truck_Axle2.stl | 90.5KB | |
| Short_Bed_Rear_Wheel.stl | 250.9KB |
