Hot Bed Sponge Box For Cleaning And Coating 3D Printer Model
The file 'Hot Bed Sponge Box For Cleaning And Coating 3D Printer Model' is (stl) file type, size is 574.2KB.
The file 'Hot Bed Sponge Box For Cleaning And Coating 3D Printer Model' is (stl) file type, size is 574.2KB.
IMPORTANT: Get the latest updates for this model here on PrusaPrinters.
In 2021, all updates and uploads of new models were moved to PrusaPrinters, of course still free and under the same conditions... :)
Like me, you have properly been wiping the printer hot bed for cleaning with a paper towel more times than you can remember - filling the paper bin with used towels.
A sponge in a box was the solution for me, maybe for you too. The sponge stays in the lit and the underpart prevents it from drying out to fast.
The box has a size to fit standard kitchen cleaning sponges (the cheap ones with heavy cleaning nylon on one side).
Just cut off the nylon part and slice it to the length you want. This is approximately 12 mm for the small box and 20 mm for the standard box.
I print a lot of PETG and therefore my sponge is wet with windows cleaner. Alternatively dish wash and water. You know best what is needed for your printing...
Don't use solvents that can dissolve the printed box - just a warning.
Update 2019.11.03: Added new version with lower lid, to make it easier to open.
>> If you like the design, please leave a Like or a Tip... thank you
| Sponge_Holder_New_Lit_v3.stl | 746.4KB | |
| Sponge_Holder_Small_v2.stl | 386.8KB | |
| Sponge_Holder_Small_v2_Split.stl | 386.8KB | |
| Sponge_Holder_v4.stl | 395.4KB | |
| Sponge_Holder_v4_Split.stl | 395.4KB |
