replacement handle for a hose spool with my name patterned around it so there is some grip to it :) or you could use the lame basic version if you are well, basic.
This accepts a 1/4 20 ~3in bolt and I used 3 washers one nut and one nylock nut.
one .5in outer diameter washer at bolt head in the deep pocket of the handle. One nut,one washer, metal crank arm one washer one nylock nut on the outside. See photos, should be pretty straight forward. I did have to run a 1/4 in drill bit through the center before assembly but I think that was because of print errors more than anything else, there is some tolerance built into the main hole.
| basic_handle.STL | 780.6KB | |
| KYLE_HANDLE.STL | 1.3MB |
