Horus X10S Portable Charger And FatShark Power Regulator 3D Printer Model
The file 'Horus X10S Portable Charger And FatShark Power Regulator 3D Printer Model' is (stl) file type, size is 161.8KB.
The file 'Horus X10S Portable Charger And FatShark Power Regulator 3D Printer Model' is (stl) file type, size is 161.8KB.
If you decide to make this, I am not responsible for any damage to your electronics. Use these at your own risk.
Portable X10S transmitter charger. These are the cases for the chargers. There are two versions of the housing. The files marked "XT" are meant for double XT60 designs so the input and output both use XT60 connectors. For the X10S transmitter, a Pololu 15V 2A regulator is required. For the Fatshark goggle regulator, I use 8V but a range of 12V to 7V can be used.
Hardware:
-- 4x M2 6mm cap or button head bolt (8mm will also work)
-- 4x M2 hex nut
Horus X10S Cable: 1.7mm barrel connector
-- Straight: https://www.digikey.com/product-detail/en/tensility-international-corp/CA-2194/CP-2194-ND/568584
-- Right Angle: https://www.digikey.com/product-detail/en/tensility-international-corp/CA-2198/CP-2198-ND/568588
Volt Meters:
-- Red https://www.digikey.com/product-detail/en/seeed-technology-co-ltd/114990164/1597-1237-ND/5487639
-- Blue https://www.digikey.com/product-detail/en/seeed-technology-co-ltd/114990166/1597-1239-ND/5487641
-- Green https://www.digikey.com/product-detail/en/seeed-technology-co-ltd/114990163/1597-1236-ND/5487638
-- Yellow https://www.digikey.com/product-detail/en/seeed-technology-co-ltd/114990165/1597-1238-ND/5487640
Pololu Step Up/Step-Down Voltage Regulator
-- Horus Charger: https://www.pololu.com/product/2573
-- FatShark Regulator: https://www.pololu.com/product/2572
-- Any other Pololu 2A Step Up/Step Down VReg should work as well but these are the ones I use. You can check the dimensions of the other Pololu regulators (as listed on their site) to determine if they are the same size as the ones listed above.
I use Pololu regulators because I trust them and they've worked for me for years. I'm unsure if other regulators will fit/work for this application.
Wire wrap: https://www.amazon.com/VELCRO-Brand-Black-2-Inch-91140/dp/B001E1Y5O6
| Bottom.stl | 59.2KB | |
| Bottom_XT.stl | 30.0KB | |
| Top.stl | 233.6KB | |
| Top_XT.stl | 235.0KB |
