Home Plant Watering System – For Blumat Pipes 3D Printer Model
The file 'Home Plant Watering System – For Blumat Pipes 3D Printer Model' is (scad,stl) file type, size is 1.8MB.
The file 'Home Plant Watering System – For Blumat Pipes 3D Printer Model' is (scad,stl) file type, size is 1.8MB.
I needed a Watering system with adjustable sprayers for my automated balcony and garden.
Since I needed a lot i did not wanted to use a gardena sprayer.
Therefore, I designed my own Micro-drip/sprayer.
I used the Blumat watering pipe and Gardena pipe. 8mm and a 12V pump with a water tank and an esp32 to controll it.
Sensors I used are Giessomat and a thermistor for soil moisture and temperature
as well as a DH22 for air humidity and temperature.
Edit: The blumat pipe fits too loose to these connectors. However the pipes of Gardena fit quite tight.
Therefor I only use the blumat from the pump to the plants and from there the gardena ones. (The gardena is also more cheaper since you can get them with 50m)
| connector.scad | 975.0B | |
| connector_blumat_to_gardena.stl | 1.1MB | |
| connector_I.stl | 1.1MB | |
| connector_L.stl | 1.2MB | |
| connector_Stop.stl | 588.7KB | |
| connector_T.stl | 1.7MB | |
| connector_w.stl | 3.0MB | |
| connector_X.stl | 2.3MB | |
| connector_Y.stl | 1.9MB | |
| handle.scad | 999.0B | |
| handle_5.stl | 94.1KB | |
| handle_6.stl | 90.9KB | |
| sprayer_connector.scad | 769.0B | |
| sprayer_connector.stl | 4.7MB | |
| sprayer_head.scad | 1.3KB | |
| sprayer_head.stl | 3.4MB | |
| threads.scad | 15.0KB | |
| water_pipe_connector.scad | 674.0B |