Holley Terminator 3.5″ Screen Mount – EZ Supports And Gauge Pod Mods 3D Printer Model
The file 'Holley Terminator 3.5″ Screen Mount – EZ Supports And Gauge Pod Mods 3D Printer Model' is (stl) file type, size is 8.5MB.
The file 'Holley Terminator 3.5″ Screen Mount – EZ Supports And Gauge Pod Mods 3D Printer Model' is (stl) file type, size is 8.5MB.
-Cleared out the reverse side of the hose clamp slot for printers with difficult breakaway supports EG stratasys.
-Added additional wire bend clearance on reverse
-Other measurements and fillets to taste
-Added gauge pods - either glue-on if you've already printed the original, or print together
-Left, right, and dual pod versions
12/22/20 - Added simple glue-on visor
NOTES: My printer is dead nuts on hole diameters. You may need to open the holes up a little if your printer runs small.
| left_pod_only.stl | 1.4MB | |
| right_pod_only.stl | 1.4MB | |
| Screen_left_pod.stl | 4.7MB | |
| Screen_only.stl | 3.4MB | |
| Screen_right_pod.stl | 4.7MB | |
| Screen_two_pods.stl | 6.1MB | |
| Visor_only.stl | 1.6MB |
