Hole Saw Guide 3D Printer Model
The file 'Hole Saw Guide 3D Printer Model' is (stl) file type, size is 88.7KB.
The file 'Hole Saw Guide 3D Printer Model' is (stl) file type, size is 88.7KB.
Guide to hold a 90mm (~3.5") hole saw in place while drilling ceramic tile. I put notches on the 4 sides to make registration (positioning) easier. Made it out of PLA at .27 mm and 10% fill. I used thin 2 sided tape to hold in place and a fair amount of water from a spray bottle while drilling (cutting). I put a small flange at the bottom of the hole, because my printer tends to make the first layer a little smaller. Not sure why???
| 90mm_Saw_Guide.stl | 1.1MB |
