If you have a Hobbywing 1060 esc, just pop the top case off and swap this on. The ESC I used was sourced from a newer Tamiya kit. Note: This is a tight fit and you'll need to make sure the heatsink is lined up and vertical for it to fit properly.
You can glue the bottom plate in or use 4x M2.5 flat heat countersunk screws (6-10mm long will work).
Orange PLA from Hatchbox was used in the picture provided.
| Novak1060_Base.stl | 52.2KB | |
| Novak1060_MainBody.stl | 295.6KB |
