These are weapon pylons, bombs and central fuel tank for the Avios Super Tucano RC airplane.
I have two versions of the wing pylons;
Pylon-Void.stl has recesses so you can glue in the standard Freewing attachment hardware, found here:
https://www.motionrc.com/products/freewing-90mm-f-16c-weapons-attachment-hardware-fj306110916
Pylon-Complete.stl has the attachment hardware "built in" to the print.
The Pylon-Sway.stl is an optional detail part you can glue to the bottom of your pylons to give it a more realistic scale appearance.
My recommendation is to use the actual Freewing hardware, since it's much more durable and holds up better. But I have also provided copies of the Freewing attachment hardware (both Male and Female) for use on the airplane wing (to attach the pylon to the wing) and any potential weapons you want to attach to the pylon.
For the fuel tank and Mk82 bomb, you will need to print out the part, then cut a slit in it using a hot knife or dremel tool, then glue one of the Freewing attachment mounts to them. Before installing the hardpoints onto your airframe, test and make sure the clearance between the flaps and ordnance meets your expectations. Also make sure the central fuel tank is placed in a way that allows clearance for the nose gear wheel.
The tolerances of my print worked for me, but you may need to scale the size of the print for a proper fit, based on your printer setup and tolerances.
I want to help out other hobbyists, so I don't charge for my designs. However, if you like what I created and find it helpful, a tip is always appreciated. Tips can be sent to: http://paypal.me/sukotto88
| Connector-Female.stl | 41.1KB | |
| Connector-Male.stl | 27.7KB | |
| DropTank-Front.stl | 7.6MB | |
| DropTank-Tail.stl | 1.3MB | |
| Mk82.stl | 240.7KB | |
| Pylon-Center.stl | 81.8KB | |
| Pylon-complete.stl | 46.4KB | |
| Pylon-SwayDevice.stl | 19.4KB | |
| Pylon-voids.stl | 35.8KB |
