HO Rerailer for model trains, modelled after the Rix Products design.
Includes a few minor supports to avoid having to support the entire ramp when printing. These supports should just snap off when the print is complete.
Measuring 29cm long, it was designed for my MAX sized printers (300x300). It almost fits on a standard 235x235 bed at a 45" angle. With a little scaling reduction on the long axis, it should print just fine.
I printed this at 0.12mm layer heights in attempt to reduce the "steppy-ness" of ramp. It's still there, but it's not as bad as the pic makes it seem. It does not affect the function of the tool.
| HO_Rerailer.stl | 38.1KB |
