A pair of clip-on hinges and a handle for a piece of 11x12 plexiglass to make a door for an Ultimaker 2. These hinges allow the door to open 270 degree, against the outside when you aren't using it.
There are two dimples for gluing in small magnets to the handle if you want a "latch" to keep it closed.
Why a door? I find it makes the bed plate heat up faster and I get less warping with ABS. It also reduces the noise a bit (the UM2 is pretty quiet already!)
| handle_for_plexi__door.stl | 45.7KB | |
| hinge_for_plexi_door.stl | 96.1KB |
![Weekly Cup Nr10 – World Cup [by Studiospass] 3D Printer Model](https://res.3axis.co/d587653b-9525-4727-819a-222dcb75d37a/images/3392d5c0-8639-44da-b3d5-7563ba693a18_thumb.jpg)
