Here's a remix on the OpenSP project I made for proper compatibility with the GBA SP ITA screen mod by FunnyPlaying.
The folder contains an editable 3D SketchUp model with the shell itself, the brightness button and the spacers to place under the membranes of Gameboy Pocket buttons (there's a proper orientation for each spacer little nub, pay attention to the attached image), as well as the STL files. Be sure to read everything on the original OpenSP project instructions. DON'T PUT TOO MUCH PRESSURE ON THE SCREEN. I think you'll be fine using the thinnest 2-sided tape you can find (3M brand). Don't use the screw inside the battery compartment (you're not supposed to even in the original OpenSP).
The glass of the screen is supposed to be a snug-tight fit, with lateral pressure helping to keep it in place. if your prints are more on the loose side of things, try a first-layer offset in your slicing software.
Any questions, feel free to ask.
| 2024_Revision_OpenSP_GBC_-_ITA.skp | 5.4MB | |
| 2024_Revision_OpenSP_GBC_-_ITA.stl | 640.3KB | |
| Brightness_Switch_and_Membrane_Spacers.stl | 137.1KB |
