a two color keychain on a single extruder
makes use of z hop and cutting mesh on cura. there is probably a way to do it on other slicers
import both models and center them. select the hijak face on cura and click on the mesh type button on the left (a picture of four models)
click cutting mesh and add the following settings
set all of them to 0
check z hop and make it 0.7 mm
slice as usual
slice the hijak face normally and print it first. then print the panel without removing the face from the bed
| hijakface2.stl | 2.5MB | |
| panel3.stl | 160.4KB |
