Higher Voltage VAWT 3D Printer Model
The file 'Higher Voltage VAWT 3D Printer Model' is (ods,STL,lua) file type, size is 791.6KB.
The file 'Higher Voltage VAWT 3D Printer Model' is (ods,STL,lua) file type, size is 791.6KB.
Files for a small VAWT.
Other parts to complete the project are:
(Qty 1) 6mm dia x 100m steel shaft,
(Qty 1) 6mm ball bearing,
(Qty 1) 6mm ID x 10mm OD x 10mm bronze bushing,
(Qty 20) 12mm dia x 3mm thick neodymium magnets,
magnet wire to suit. (I used 163 turns of 32AWG wire for a lower voltage version, and 699 turns of 38AWG for a higher voltage version)
The spreadsheet is a LibreOffice file.
The .lua files are for FEMM.
I found that I had to open the ID of the bronze bushing just a bit using a small (1/4" dia) round file. It didn't take a lot, but the tolerances were so tight that the shaft would bind if I didn't.
| 12VMicroVAWT.ods | 74.0KB | |
| HVVCoilHolder.STL | 508.7KB | |
| HVVCollet.STL | 31.9KB | |
| HVVCone.STL | 88.5KB | |
| HVVSpacer1p8.STL | 26.0KB | |
| HVVSpacer2p2.STL | 26.0KB | |
| HVVTurbine.STL | 1.2MB | |
| HVVWindingFixture.STL | 187.4KB | |
| Magnets12x3nosteel.lua | 3.4KB | |
| Magnets1SteelBacking.lua | 3.6KB |
