This is a story tick I made to transfer measurements between cabinet drawer runners. The story stick uses Lufkin steel rulers which are easy to come by here in Australia
(https://www.bunnings.com.au/lufkin-600mm-24-stainless-steel-rule_p5662992). I've used this on the 300mm, 600mm, and 1,000mm Lufkin rulers.
For your reference, the Luflkin rulers are approx 1.05mm thick and 28.6mm wide.
A few of the features I added:
The following hardware is required
The M6 thumb screw is threaded and works fine printed. I found it was a little tight, so I used a M6 tap to clean it up so that it was easier to use. Make sure to use some light machine oil on the bolts when you assemble.
| Bottom.stl | 218.8KB | |
| Top.stl | 33.7KB |
