Cam style clips for the HICTOP printer to Zip tie cabling to.
I made it thicker to make it stronger.
To install clip, insert cam into slot on bar and pull the outer tabs slightly while rotating clockwise. If you lift too hard on outer tabs you will break the cam off. Lift the tabs just enough to get them over the rail. The slit in the middle of the clip will flex and allow the locks to slip over the bar into the slot with the cam twisting into place. The clip will still slide left and right; if you position them where you need them and only tie the cables down after you have them positioned, your cables and clips will stay where you put them.
This is the kit I purchased from Harbor Fright to remove the fill material from the zip tie holes. http://www.harborfreight.com/56-piece-precision-knife-set-36410.html
| CableTie.FCStd | 28.5KB | |
| CableTie.FCStd1 | 14.1KB | |
| CamBar.FCStd | 5.7KB | |
| CamBar.FCStd1 | 5.6KB | |
| InternalCamLockR2.FCStd | 39.9KB | |
| InternalCamLockR2.FCStd1 | 37.5KB | |
| InternalCamLockR3.stl | 64.8KB |
