I have fine tuned the connectors for this box. they have small tolerances but each one is tapered towards the bottom to allow them to fit a little easier. They can link together to create different designs/combinations. I have included different height versions as well as ones with and without the inside dividers. They are designed to print on a MPMD and use most of the bed. About 85mm at the widest. Inside radius is about 35mm and outside radius is about 42mm.
I didn't want to go much bigger as many people have bed levelling issues with the MPMD if they have not calibrated them properly.
I have included a test print piece that can be used to check the sizing and tolerances.
If you find pieces a little tight try sanding or filing the connectors slightly to remove any roughness or extra filament. If you are finding them difficult to remove place one of the pieces on a counter edge (connectors slightly overhanging) and using a small allen wrench or other small bar tap down on the centre connector to allow the piece to move straight down. If it is really tight you might need to alternate with the outer connectors and then tap the centre connector.
Allow them to cool before connecting them or place them in the freezer before trying to join them if they are too tight.
Sorry but I did't flip the STLs so you will have to rotate them in your slicer so they are sitting on their base.
| Hex2_v8_10mm.stl | 71.2KB | |
| Hex2_v8_10mm_no_divider.stl | 71.2KB | |
| Hex2_v8_20mm.stl | 71.2KB | |
| Hex2_v8_20mm_no_divider.stl | 71.2KB | |
| Hex2_v8_30mm.stl | 71.2KB | |
| Hex2_v8_30mm_no_divider.stl | 71.2KB | |
| Hex2_v8_40mm.stl | 71.2KB | |
| Hex2_v8_40mm_no_divider.stl | 71.2KB | |
| Hex2_v8_50mm.stl | 71.2KB | |
| Hex2_v8_50mm_no_divider.stl | 71.2KB | |
| Hex2_v8_5mm.stl | 71.2KB | |
| Hex2_v8_5mm_no_divider.stl | 71.2KB | |
| Hex2_v8_Test_Print.stl | 70.2KB |
