Hex, Router, And Drill Bit Storage Or Inlay – Parametric And Customizable 3D Printer Model
The file 'Hex, Router, And Drill Bit Storage Or Inlay – Parametric And Customizable 3D Printer Model' is (scad,stl) file type, size is 4.1KB.
The file 'Hex, Router, And Drill Bit Storage Or Inlay – Parametric And Customizable 3D Printer Model' is (scad,stl) file type, size is 4.1KB.
fully parametrized and customizable storage or inlay for: hex bits, router bits or drill bits
use OpenScad, open bitstorage.scad and change the parameters:
x-Dimension
y-Dimension
height
Columns and rows for bits
corner radius - same x- and y-dimension and set corner radius to half of x-dimension to get a round inlay
sides of bit hole - 6 for hex bit or 100 for round holes
bit diameter - 7.5 should fit for hex bit
bit hole deepness
When done → render (f6) → export stl → print
To make sure the bit fits properly print a test with small dimension like 15 x 15mm and only 1 row and 1 column. If the bits fits to tight increase the value to 7.6 or 7.7 in bit diameter. Otherwise reduce if the bit is too lose.
Update 18.12.22 - fixed bevel issue
| bitstorage.scad | 3.5KB | |
| bitstorage.stl | 34.8KB |
