Disclaimer about the STL files: All these files are remixed from other STL sources with MS 3D builder.
This is an angled hex bit holders that works best for tool chests that does not have enough height for longer bits. I notice most of the hex bit holders I found here are all point straight up, but that poses a problems because I am limited to taller drawers in my tool cabinet.
I have 2 different sizes to choose from, 10 or 14 bits wide. I know it is a strange combo but that works well for my setup.
• Hex Bit Holder 10 bits v03.stl
• Hex Bit Holder 14 bits v03.stl
Just incase if you want the stackable side bins too. There are 2 different versions, one has two dividers and the other has one.
• Bin 152x65x20 Third.stl
• Bin 152x65x20 Half.stl
Note: Your printer might not be tuned the same so the hex bit may fit too tight or loose. You might need to adjust the print setting to accommodate it. The easiest thing is to increase or decrease your flow rate. I have included a test file, so you do not need to print the whole Hex Bit holder to find out later the setting is off:
• Hex Bit Holder Test.stl
| Bin_152x65x20_Half.stl |
| Bin_152x65x20_Third.stl |
| Bit_Holder_Wall._Mounted.stl |
| Hex_Bit_Holder_10_bits_v03.stl |
| Hex_Bit_Holder_14_bits_v03.stl |
| Hex_Bit_Holder_Test.stl |
