This housing fits a Heltec ESP32 OLED Board V3 Type-C SX1262 board without the need to buy screws or glue anything.

This case is meant to be used inside or light outside duty.
The case was used for a Meshtastic project.

*fun fact, you can go to homedepot/lowes and ask them nicely to dig through their battery recycle bin to scrap tool batteries for 18650 cells. It's dangerous to take apart battery packs but rewarding.

Instructions--------------------------------------------------------
Here is the supplies list,
-Battery holder
https://a.co/d/5htOD2Q
-Switch used
https://a.co/d/fEc6oFc

Build the battery pack in parallel with all cells.
(optional) Add 1S protection circuitry to battery pack.
Slide battery pack face down into housing.
Press battery pack firmly into housing.
Install switch into housing.
Solder a wire from one of the battery terminals to switch.
Turn switch off (O) to not accidently power on board.
Solder battery connector (Match polarity) that came with board to switch and other wire from battery pack.
Weave antenna wire though the "front plate" and connect it to board.
Weave battery connector though the "secure rail".
Fully slide "secure rail" into place.
Tighten antenna connector to housing.
With two thumbs, press "front plate" into housing.
Slide "sliding key" into top of housing.

Have fun with Meshtastic!