Hellraiser Puzzle Box: The Labyrinth Configuration (Abyssus Daedalus) 3D Printer Model
The file 'Hellraiser Puzzle Box: The Labyrinth Configuration (Abyssus Daedalus) 3D Printer Model' is (stl) file type, size is 3.1MB.
The file 'Hellraiser Puzzle Box: The Labyrinth Configuration (Abyssus Daedalus) 3D Printer Model' is (stl) file type, size is 3.1MB.
Crashjensen made a great model of Steelgohst's original design (https://www.deviantart.com/steelgohst/gallery/) of the Labyrinth Configuration. I decided to separate the sides so that they took less filament to print, and to allow for layer based filament changes. Also, I wanted to reverse the extrusion on the faces as I thought it would look closer to the original schematic above. Being that there are six sides, two of each of the sides (1,2, and 3 or 1x,2x, and 3x) should be printed. Alternately, the fullplate versions are ready to print and go! The pieces are connected with a simple tongue and groove system and should hold together rather well, even without glue. If you want to print this box with a filament change, the etched area starts at 5.2 mm on each piece, so, as I did you can change from your base filament (3dSolutech "Real Black" in my case to CC3D "Silk Silver") to a second filament at that height. No paint needed! No supports needed! Just print and snap the model together! Summon Cenobites! Yay!
| The_Labyrinth_Configuration_01.stl | 368.9KB | |
| The_Labyrinth_Configuration_02.stl | 506.6KB | |
| The_Labyrinth_Configuration_03.stl | 807.7KB | |
| The_Labyrinth_Configuration_Extrusion_Fullplate.stl | 3.2MB | |
| The_Labyrinth_Configuration_Inverse_Extrusion_Fullplate.stl | 3.3MB | |
| The_Labyrinth_Configuration_x_01.stl | 406.9KB | |
| The_Labyrinth_Configuration_x_02.stl | 359.4KB | |
| The_Labyrinth_Configuration_x_03.stl | 875.4KB |
