Printed mine on an ender 3 V2 with standard filament settings. No rafts or supports were required even though my slicer recommended it. I modeled this in fusion 360 to make sure the parts lined up. I attached the project archive so you can make necessary adjustments. You may have to adjust the grips a tiny bit depending on the crib you mount it on. The current size of the gap is 28 ish mm. It does have a hinge of sorts that has three holes where you can adjust the tilt of the camera.
For the camera mount, there was a piece included with the camera (its a little black piece) that I screwed in to the top of the hinging piece. I had to offset the piece a little and then screwed through the print to secure it. I also used some super glue on that piece to make sure it didnt wobble.
| Body.stl | 31.1KB | |
| Crib_Camera_Mount_v4.f3d | 396.6KB | |
| Grips.stl | 48.5KB | |
| IMG_0824.HEIC | 945.5KB | |
| Pins.stl | 141.5KB |
