Hello, Stabby Kitty + Machete – Scaled 3D Printer Model
The file 'Hello, Stabby Kitty + Machete – Scaled 3D Printer Model' is (stl) file type, size is 860.17 KB.
The file 'Hello, Stabby Kitty + Machete – Scaled 3D Printer Model' is (stl) file type, size is 860.17 KB.
Loved the idea of this. Got some Kitty's that look just like the ops picture but ops models wouldn't fit. (My cats are 10.25 cm tall) Needed scaling and squishing to fit their face. Three test prints got me to this final version.
And Jason Voorhee's needs a Machete not a Knife. Found the perfect model and scaled appropriately.
Printed the Mask in White and the machete in Gray. Attached with a drop of hot glue. Be sparse on the machete to avoid adding to much weight to the arm. Also attach it kind low, too high will overweight the pendulum.
I had to add a little weight to the pendulum to support the extra weight of the Machete. I was able to use the screw from the Base that holds the shipping cover on to get the balance right. See pictures. It's magnetic, but also used some hot glue to make sure it stays on.
Modified(07/2/2020): Added 2x size mask, but trying to keep it thin. One is only partially curved in depth direction, the other is full stretched to 2x depth. Also added 2x sized machete, but also keeping it thin, but not fully thin as the smaller one. Might be too thin to print the edges.
| machete_up.stl |
| machete_up_2x_thin.stl |
| StabbyMask_Ventilated_2x_thin.stl |
| StabbyMask_Ventilated_2x_thin_curved.stl |
| StabbyMask_Ventilated_42_21.6_34.stl |
